How to Convert a Kamplite RL2 eccentric block

Instructions and How-to from members. Safety posts.
Locked
User avatar
242burner
Colmanaholic
Posts: 441
Joined: Sun Feb 13, 2011 5:09 am

How to Convert a Kamplite RL2 eccentric block

#1

Post by 242burner »

With help from the members of the board I decided to convert this Triple Burgandy RL2 Kamplite by AGM to run on a standard Coleman 220 generator.
You will need a Dremel, a 1/16 drill bit, a Coleman eccentric block as a guide, and a pump rod.



Comparison of the eccentric blocks:


The AGM eccentric block is the same size as a standard Coleman pump rod. Cut it to length. I decided to drill a 1/16 hole FIRST then cut the top notch. I then used the original eccentric block as a guide for the tip cleaner notch. In order to not go too deep I put the rod in the vise and ground out the notch. It was over in seconds

When you are done you will have this:



Two shots of a nice bright lantern.





Thanks to Curtludwig and scouterjan.

1928 L-220 "Slant" from Russ
1919 Air-O from Jerry
500 Speedmaster

Locked